Eurosens Dash device should be connected to power, ground, ignition voltage signal and RS-485 interface (which connects GPS-tracker and installed fuel level sensor). It is placed near GPS tracker under the dashboard and doesn’t have a long cable. Eurosens Dash works in listen-only mode and reads fuel level data during GPS-fuel level sensor interaction. […]
Eurosens Dash emulates resistive signal of a vehicle fuel level sensor. It is used when we want to install accurate fuel level sensor of capacitive type (like Eurosens Dominator) instead of vehicle sensor and avoid drilling a new hole.
When we cannot use Eurosens Dash:
1. Vehicle sensor does not have an resistive output but uses […]
Eurosens Dock device is connected to power, ignition signal (voltage) and vehicle sensor analog output (or dashboard fuel gauge input). Usually it is placed near GPS-tracker besides the dashboard panel and doesn’t have a long cable. If you don’t want to analyze the dashboard’s wiring – you can use sensor output directly from the […]
Eurosens Dock device improves the output voltage signal of a resistive vehicle fuel level sensor. If vehicle sensor has capacitive technology or build-in power stabilizer – Eurosens Dock will have very small effect. Also it can’t work with another types of interfaces (frequency, current-based). Eurosens Dock is able to read only voltage sensor output.
Note, […]
There are 2 types of calibration : calibration of sensor and
calibration of tank
Calibration of sensor : teach sensor by its new length after sensor
cutting. It is easy procedure, for example you can fill sensor by fuel
and click EMPTY/FULL buttons in […]
Eurosens Dominator modular sensors are no more expensive than traditional design sensors.
Eurosens Dominator sensors are certified according to the requirements of ТР ТС 018 ТР (Russian Customs union), have the European E-mark certificate and explosion protection certificate according ТР ТС 012 with marking 0ExiaIIBT6 X.
If there is a CAN or RS485 interface, their number depends on the capabilities of the GPS tracker, usually not less than 5. We can even connect several level sensors to the acquisition device via the RS232 interface. In this case, the sensors exchange information with each other via the internal K-line network, and […]
In this case, we can help to calculate calibration table which will be programmed into the fuel level sensor Eurosens Dominator. Calculation will be based on tank shape information. Inclination of the tank could be taked into account. For simple shapes like horizontal cylinder of cystern (without inclination and shape defects) you may use […]
Calibration of level sensor Eurosens Dominator after trimming is not required! It will save you 5-10 minutes on each sensor. Calibration is performed automatically when the tank is calibrated.
