Eurosens DDS

Learn more!

For vehicles with leaf spring suspension!

Leaf spring deflection sensor with digital interface and improved precision.

Learn more!
    Eurosens DDS converts the angle of rotation of the sensor’s lever to  output signal. As the transducer is used magnetoresistive sensor.At the output of the sensor is formed stabilized analog voltage signal, which corresponds to the angular position of the pivot arm, changing depending on the load on the axle vehicle.

Eurosens DDS A output voltage:

Rotation angle, degrees Output voltage, V
– 40 1,54
– 30 1,78
– 20 2,02
– 10 2,26
0 2,50
10 2,74
20 2,98
30 3,22
40 3,46

Eurosens DDS 485 uses LLS/MODBUS protocol. Eurosens DDS CAN uses CAN bus J1939 protocol with configurable PGN. After installation and wiring Eurosens DDS you should perform a calibration in which you are mapping the output voltage to the load on the suspension of the vehicle.

Eurosens DDS flyer
Eurosens DDS 485 configuration 
Eurosens DDS CAN configuration 
Eurosens DDS 485 configurator
Eurosens DDS/DPS CAN configurator
Eurosens DDS 485/CAN data protocol
Eurosens Difference onboard weighing system (and sensors) installation
Eurosens DDS 485 firmware (1.1)
Eurosens DDS CAN firmware (1.2)

More about air suspension …