Eurosens Dominator AF

Now you do not need to keep in stock a whole range of sensors with different interfaces. EUROSENS Dominator AF replaces the sensors with analog output to 5V, analog output to 10V, with frequency output in the range of 500 – 1500 Hz.

    • High-precision measurement
    • Output signal type can be adjusted
    • Built-in temperature compensation
    • Modular build
    • Strong electronic circuit protection
    • Sealed automobile connector on sensor body
    • Efficient packaging, installation and sealing

Dominator fuel level sensors are designed to minimize the operating costs of fuel consumption monitoring system for the entire period of its operation.

  • Powerful electronic module protection. External power voltage protection up to 170 volts.
  • The modular design allows not only cut the sensor for a specific vessel, but also to extend the electrode. Its useful when you reinstall the system to another object. Sensors of traditional non-modular design can’t be extended and once shortened electrodes can’t be replaced.
  • Easy sealing of the sensor from disconnection cable and sensor removal.
  • The electrodes can be easily disassembled and cleaned. Sensors of conventional design can be contaminated in the gap between electrodes that require complex maintenance. Dominator electrodes can be cleaned by the customer without warranty violations.
  • The modular design makes it easy to provide technical support of installed sensors.  We can easily localize the problem either in the sensor “head” or in sensor electrodes, because electrodes can be disconnected from sensor “head”.
  •  If the fault is in the “head” of the sensor – replacement can be done even by the end user – the owner of the equipment. Thanks to bayonet, fast-lock replacement is very easy and takes about 10 minutes. It is much cheaper than travel costs of installation staff.
  • After sensor “head” replacement you don’t need to make tank calibration again (unlike traditional design sensors).
  • Warranty term – 5 years.
Power voltage, V 9 – 32
Reverse polarity protection Yes
Max error ±1%
Temperature range,°C -40 – +85
Output voltage, V 0,5 – 9,5
Output frequency, Hz 500 – 1500
Seal rating IP 67
Galvanic isolation up to 500V

Eurosens Dominator AF advantages for installers:

  • Modular design allows to create sensor of desired length from stock electrodes
  • For compatibility with various telematic modules we have many settings. For analog voltage signal you can set output voltage range, for frequency output it is possible to change pull-up mode.
  • Due to fast and easy  installation via bayonette mount you don’t need to send a specialist for sensor replacing. You can just send a new sensor to customer.
  • Eurosens Dominator AF looks impressive for customer.
    Configuration manual
    Configuration software (extended version)
    Dominator AF firmware v.2.3

    serial number starts with 70
    Dominator AF rev.2 firmware v.1.7

    serial number starts with 75,76,77
    Dominator AF passport
Eurosens Dominator manual
Eurosens Dominator certificate

(E-mark)

 

For developers : Eurosens Dominator 3D CAD drawings

Eurosens Dominator IGS file
Eurosens Dominator STEP file

 

Use with:

Eurosens Destination 01_200x200

Eurosens Destination

Dominator Electrode 1&2_200x200

Dominator Electrode

Eurosens Cable

Eurosens Cable