Install

Gallery

Fuel consumption meters with NMEA2000 interface on boats and yachts

, ,

Fuel consumption meters with NMEA2000 interface on boats and yachts

, ,

The installation of fuel consumption meters on ships or yachts is an objective necessity to determine the cruising range, which strongly depends on the wave situation and cannot be accurately calculated from the data of the fuel level sensor in the tank, as well as to improve engine efficiencty based on the instantaneous fuel consumption of the engine. So we have to display instant fuel consumption data onboard, and it doesn’t mean extra display installation is required.

(more…)

Gallery

Decoding the CAN bus data with can2sky.com service

Decoding the CAN bus data with can2sky.com service

Many GPS tracking installations are bonded with CAN bus data analysys. On-board electronic modules contain a lot of data about the operation of the machine – sensor values, loading or unloading events, diagnostic trouble codes and much more. Data can be transmitted either using standard exchange protocols (FMS protocol / SAE 1939), typical for trucks and commercial vehicles, and non-standard (cars), or according to the undocumented parts of standard protocols.

(more…)

Gallery

Eurosens Degree Bt tilt angle sensor connection to Smart GPS tracker

Eurosens Degree Bt tilt angle sensor connection to Smart GPS tracker

How to connect Eurosens Degree BT tilt angle sensor to Smart GPS tracker (from Navtelecom company) in tilt angle mode/events detector mode. (more…)

Permalink Gallery

Eurosens Degree Bt tilt angle sensor connection to Teltonika FMBXXX

Eurosens Degree Bt tilt angle sensor connection to Teltonika FMBXXX

Wireless tilt angle sensor Eurosens Degree BT has different operation modes. Lets see how it is connected to the popular GPS trackers Teltonika FMB XXX in the modes : tilt angle monitoring and events detection, concrete mixer truck monitoring, boom monitoring. (more…)

Permalink Gallery

Eurosens Dominator Bt connection to the Smart GPS (Navtelecom) over Bluetooth BLE

Fuel theft alarm
Permalink Fuel theft alarmGallery

Instant fuel theft alarm with Eurosens Dominator fuel level sensors

Eurosens Dash
Permalink Eurosens DashGallery

Setting up the Eurosens Dash controller

Setting up the Eurosens Dash controller

Eurosens Dash resistive fuel level sensor emilator is designed to control the fuel gauge on the dashboard. Eurosens Dash reads the fuel level (volume) value via the RS-485 interface and the LLS protocol. (more…)

Permalink Gallery

Eurosens Dominator Bt connection to the GalileoSky GPS over Bluetooth BLE

Eurosens Dominator Bt connection to the GalileoSky GPS over Bluetooth BLE

Терминалы Galileosky  имеют встроенный модуль Bluetooth BLE, который обеспечивает считывание данных с беспроводных Bluetooth-датчиков. Рассмотрим подключение датчиков уровня топлива Eurosens Dominator Bt (more…)

Permalink Gallery

Eurosens Dominator Bt connection to the Smart GPS (Navtelecom) over Bluetooth BLE

Eurosens Dominator Bt connection to the Smart GPS (Navtelecom) over Bluetooth BLE

Popular GPS trackers Smart produced by Navtelecom company has built-in Bluetooth module. It can read the data from wireless Bluetooth sensors. Here is how to connect wireless fuel level sensor Eurosens Dominator Bt to the Smart GPS tracker. (more…)

Permalink Gallery

How to connect eurosens fuel level sensors and fuel flowmeters to Galileosky 7.0x via MODBUS (RS485)

,

How to connect eurosens fuel level sensors and fuel flowmeters to Galileosky 7.0x via MODBUS (RS485)

,

It may be challenging to add completely different sensor types (a fuel level sensor and a fuel flowmeter) to one RS 485 interface of a GPS tracking device. The reason is the different data exchange protocol that corresponds to different sensor types. However, there is no such problem if we use the universal MODBUS protocol.

This article will explain how to connect Eurosens Dominator RS fuel level sensor and Eurosens Delta RS fuel flowmeter to Galileosky 7.0x GPS tracker.
(more…)