Each of the installed sensors in the settings of the weighing system can be assigned up to 3 calibration tables, which makes it possible to obtain up to 3 separate values of axial loads.
The cost depends on system complement very much. For choices of system complement need to answer on following questions:
1. Is it necessary to determine the weight of the transported cargo or only the axle load?
2. Is there a trailer or semi-trailer, if so, can one tractor work with […]
Wialon, GeliosPRO, Fort-Monitor, AutoGRAPH successfully build graphs of axial loads and load weight. But to get the correct report on the volume of cargo transported rarely manages.
The standard functionality of monitoring platforms makes the following actions when building reports:
• determines the beginning and end of the cargo flight (based on data […]
Axial loads and load weight arrive at the monitoring server as fuel level values from several sensors (up to 7).
This simplifies integration into the monitoring system (as it does not require the support of the new exchange protocol), but requires from the monitoring software the possible flexible use of the obtained data. We should […]
The terminal must suffice the following conditions:
• Have an RS485 interface
• Support LLS protocol (support for fuel level sensors via RS485 interface)
• The number of fuel level sensors supported by the LLS protocol and RS485 interface must be at least 7.
Examples of compatible terminals: Galileosky.
The order is described in the installation manual, which you can download from our website //mechatronics.by/products/load-control/ Also you may look at our youtube channel
Features: Installation of sensors Eurosens Difference 01 (air spring suspension) requires tie-in pneumatic lines. Use the mounting kit from the manufacturer, but it is necessary to pre-specify the diameter of the […]
A measurement error will depend not only on the weighing system, but also on the vehicle device, its suspension system and mass-geometric parameters.
From the experience of installations of these systems, we can say that:
The measurement error of the axle load for vehicles with air spring suspension is 1-5%, for vehicles with leaf spring suspension […]
If you only need to control the axle load – you can do only with sensors!
Sensors are connected to the monitoring terminal via an analog input, if it is necessary, you can also connect Eurosens Display F1 or Eurosens Display RS to display the load. The system is calibrated using a platform scale. […]
1. Sensors
Air spring suspension – Eurosens Difference 01
Leaf spring suspension – Eurosens Difference 02
You can also use any sensors with analog output: regular vehicle sensors, load cells, and others.
2. Controller Eurosens Difference-T
Why is it needed:
• Receives information from one load sensor with an analog output.
• It stores […]
It executes the following functions:
• Individual axle load measurement for truck and trailer.
• Cargo load calculation.
• Axle overload alarm.
• Show axle load and cargo weight at the driver’s display.
• Transmit axle load and cargo weight values to the […]
